Bit Technology- Interfitting Teeth and Cone Offset

Interfitting Teeth and Cone Offset

The idea of interfitting teeth (Figure 3-2a), makes it possible to have large bit parts, and allows the inner row of teeth to cut new formation on each rotation. Interfitting also offers some degree of self-cleaning. One result of this interfitting is that each of the three cones are different.

Cone offset (Figure 3-2b), is caused by the journal centerline not intersecting the bit centerline (or bit center of rotation). The distance that the journal centerline misses the bit centerline (measured perpendicular to the journal centerline at the center of rotation) is the offset.

The skew point is an arbitrary point along the journal centerline and is the angle formed by the offset, the centerline of the journal, and a line from the bit center to the skew point. The skew direction is always “positive”, or in the direction of rotation. This permits the tips of the teeth to “ream” the hole to full gauge. “Negative” skew would have the gauge face rubbing the hole wall, increasing gauge wear.

As with the journal angle, the offset will be different in each type of formation. In soft formation bits, the maximum offset (3o skew angle) is used to increase the gouging, scraping action. Medium formation bits add a limited offset (2o skew angle) to develop cutter action. While hard formation bits have no offset, to minimize gouging and scraping.